Installation and Upgrade Guide

Using DSM/SCM to Install SPRs

G06.24 Software Installation and Upgrade Guide—528593-005

A-9

If a System Load Is Required

1. Rename the current files:

tacl> rename newres, oldres

tacl> rename newnres, oldnres

2. Run the INSTALL^TEMPLATES macro again and use the file names newres and

newnres.

The following message indicates that the templates are successfully installed:

>$SYSTEM.SYS00.FUP /NAME $Z03M,INV :INBUF.1,OUTV :OUTBUF.1/

File Utility Program - T6553D45 - (14APR2000) System \TINY

SECURE

($SYSTEM.TEMPLATE.NEWRES,$SYSTEM.TEMPLATE.NEWNRES),"NUNU"

*** INSTALL^TEMPLATES: Completed sucessfully ***

If a System Load Is Required

If OSM is installed and configured, you can use these instructions to load your RVU.

Halt the Processors

1. If necessary, log on to the TSM Low-Level Link Application. If you are using OSM,

log on to the OSM Low-Level Link.

2. On the toolbar, select Processor Status to open the Processor Status dialog box.

Select the processors to be halted.

3. From the Processor Actions list, select Halt.

4. Click Perform action.

5. Click OK when asked if you are sure you want to halt.

6. When the Action Status box confirms that all the processors have been halted,

close the Processor Status dialog box.

Do not log off the OSM Low-Level Link or TSM Low-Level Link Application.