Installation and Upgrade Guide

Installing the Latest DSM/SCM SPRs and Client

Software

G06.24 Software Installation and Upgrade Guide—528593-005

B-13

Rename the Applied DSM/SCM D46 Files

1. Stop DSM/SCM:

> VOLUME $dsmscm_vol.ZDSMSCM

> RUN STOPSCM

where $dsmscm_vol is the DSM/SCM volume.

2. Run ZPHIRNM:

> RUN ZPHIRNM $volume.SYSnn

where SYSnn is the current SYSnn (because no SYSGEN or system load is

required).

3. When asked if you want to use a log file with the session, enter Y.

4. When prompted, enter a file name for the log file.

ZPHIRNM displays this message:

Log file, filename, was successfully created.

ZPHIRNM processes the file renaming.

5. Verify that ZPHIRNM ran successfully by reviewing the specified log file.

If Running INSTALL^TEMPLATES Is Required

If the operator instructions state that you should run INSTALL^TEMPLATES to update

EMS template files, you must be logged on as the super ID (255,255) user to run the

INSTALL^TEMPLATES macro. This macro cannot be run with the NOWAIT option and

takes approximately ten minutes to finish.

Since the G06.10 RVU, if there is a resident template file in any of the input

subvolumes, the INSTALL^TEMPLATES macro displays this error:

Invalid nonresident template file -- not key sequenced:

$SYSTEM.ZTEMPL.NEWRES

*** INSTALL^TEMPLATES: Terminated due to error ***

HP recommends that you designate another subvolume (for example,

$SYSTEM.TEMPLATE) to contain the output from INSTALL^TEMPLATES. When you

specify this location, a non-resident template file is not present in ZTEMPL, and the

error does not appear.

1. Set the volume and subvolume to $SYSTEM.ZINSAIDS:

-> volume $system.zinsaids

2. Load the TACLMACS file:

-> load /keep 1/ TACLMACS