Installation and Upgrade Guide

Installing the Latest DSM/SCM SPRs and Client

Software

G06.24 Software Installation and Upgrade Guide—528593-005

B-15

Restart Applications

1. Rename the current files:

-> rename newres, oldres

-> rename newnres, oldnres

2. Run the INSTALL^TEMPLATES macro again and use the file names newres and

newnres.

The following message indicates that the templates are successfully installed:

>$SYSTEM.SYS00.FUP /NAME $Z03M,INV :INBUF.1,OUTV :OUTBUF.1/

File Utility Program - T6553D45 - (14APR2000) System \TINY

SECURE

($SYSTEM.TEMPLATE.NEWRES,$SYSTEM.TEMPLATE.NEWNRES),"NUNU"

*** INSTALL^TEMPLATES: Completed sucessfully ***

Restart Applications

You can now start your application software. Follow your site’s procedures for

executing the system configuration and startup (command) files to accomplish this.

DSM/SCM is often started automatically by a system command file; if not, you must

start it manually as described next.

Before Starting DSM/SCM

Depending on your RVU, DSM/SCM will not work properly if SQLCI2 has changed and

DSM/SCM is still using the old version.

1. Check that TMF is started:

> TMFCOM STATUS TMF

2. Verify your current configuration against the cold start configuration in PATHHOST

(or PATHTARG) to check that the current configuration reflects all changes you

have made.

3. Run the PATHCOLD macro from the ZDSMSCM subvolume to cold start the

Pathway configuration.

Start DSM/SCM

1. Run the STARTSCM macro from the ZDSM/SCM subvolume to start DSM/SCM:

> RUN STARTSCM