Installation and Upgrade Guide

Updating SWAN Concentrator CLIP Firmware
G06.24 Software Installation and Upgrade Guide—528593-005
C-15
Step 2: Point SWAN Concentrators to the New
Firmware Object Code File
Or (using SCF), enter:
2-> status server $zzwan.#s01.*
WAN Manager STATUS SERVER for CLIP \ELI.$ZZWAN.#S01.1
State :......... STOPPED
.
.
WAN Manager STATUS SERVER for CLIP \ELI.$ZZWAN.#S01.2
State :......... STOPPED
.
.
WAN Manager STATUS SERVER for CLIP \ELI.$ZZWAN.#S01.3
State :......... STOPPED
.
.
Step 2: Point SWAN Concentrators to the New Firmware Object
Code File
Change the default location for the SWAN firmware object code file with the SCF
ALTER ADAPTER, KERNELCODE command:
-> SCF ALTER ADAPTER $ZZWAN.#conc-name,
KERNELCODE swan-kernel-micode-file-name
By default, the SWAN firmware object file (C7953P00) resides in the
$SYSTEM.CSSnn subvolume (nn is the number of the $SYSTEM.SYSnn where the
new operating system image resides).
For example, to specify SYS04 in the DSM/SCM Build/Apply request for G06.24, enter:
SCF ALTER ADAPTER $ZZWAN.#S01, KERNELCODE $SYSTEM.CSS04.C7953P00
The SCF ALTER ADAPTER, KERNELCODE command changes the firmware file
location for all CLIPs associated with a SWAN concentrator.
Note. The SWAN concentrators (ADAPTER object) must be in the STOPPED state (as
performed in Step 5) for this command to work.
Note. When you specify an alternate firmware file location from the TSM Service Application
Specify Firmware File Location dialog box (see Step 8 on page C-17
), the location is
changed only for those CLIPs being updated at the time.