Installation and Upgrade Guide

Updating SWAN Concentrator CLIP Firmware
G06.24 Software Installation and Upgrade Guide—528593-005
C-18
Step 4: Start the SWAN Concentrator and CLIPs
Step 4: Start the SWAN Concentrator and CLIPs
After the SWAN CLIP firmware has been updated, use the TSM Service Application or
SCF to start the updated SWAN concentrator and CLIPs.
Step 5: Verify That the SWAN CLIPs Are Running the Latest
Firmware
Verify that the updated SWAN CLIPs are in fact running at least the firmware version
by using one of the methods described under Check Firmware Version Currently
Running in SWAN CLIPs on page C-10.
Step 6: Start Stopped Lines (If Necessary)
Starting the SWAN concentrators in Step 4: Start the SWAN Concentrator and CLIPs
should bring all lines into the STARTED state. Check the status of the lines and, if
necessary, start any stopped lines on the started CLIPs for each SWAN concentrator.
Using the OSM Multi-Resource Actions Dialog
Box to Update SWAN and SWAN 2 Firmware
For SWAN firmware, you can use the OSM Multi-Resource Actions dialog box to select
any or all CLIPs. Then, you can stop all selected CLIPs, update their firmware, then
start them again. You can also right-click on the CLIP, select Actions, and select
Firmware Update from the Action list.
You must be running a G06.08 or later RVU, have already installed the SWAN firmware
version T7953AAG or later, and have installed and configured OSM.
For troubleshooting information on SWAN or SWAN 2, see section 4, “Correcting
SWAN Concentrator Hardware Problems” in the SWAN Concentrator and WAN
Subsystem Troubleshooting Guide.
Summary of Steps for Upgrading From T7953AAG and Later
SWAN Firmware Versions (Using OSM)
You cannot update the SWAN concentrator firmware unless you have installed and
configured OSM.
•
Step 1: Stop the SWAN Concentrator and CLIPs
•
Step 2: Check the Location and Version of the SWAN Firmware
•
Step 3: Initiate the Firmware Update
•
Step 4: Start the SWAN Concentrator and CLIPs
For information on starting and stopping devices, displaying attributes, see the OSM
Service Connection online help.