Installation and Upgrade Guide

Overview of Installing G06.24
G06.24 Software Installation and Upgrade Guide—528593-005
1-15
Upgrading NonStop S-Series Servers
Upgrading NonStop S-Series Servers
If you are upgrading from the NonStop S7000 system (NSR-W), and before you
upgrade to S76000 (NSR-X), S86000 (NSR-Y) / S7600 (NSR-E), NonStop S7800
(NSR-J), S78000 (NSR-H), S88000 (NSR-Z), you must change the
SYSTEM_PROCESSOR_TYPE in the ALLPROCESSORS paragraph in the
CONFTEXT file. In the CONFTEXT file, you can specify only one processor type.
Neither NSR-D (S7400), nor NSR-W (S7000) can be specified in a system with mixed
processor types.
For processor model S70000 running G06.24 and later, you must change the
processor type from NSR-G to NSR-C in the ALLPROCESSORS paragraph in the
CONFTEXT file. Failure to change the processor type when loading the new SYSnn
causes an immediate %100441 halt. All other references to NSR-G are still valid,
which means that any query performed on the system will return NSR-G if the PMF is a
model 1951 PMF CRU (S70000).
11. Update EMS template files (if
necessary).
INSTALL^TEMPLATES
TACL macro
If Running
INSTALL^TEMPLATES Is
Required on page A-7
12. Halt the processors. TSM Low-Level Link
Application or OSM Low-
Level Link
Halt the Processors on
page 11-2
13. Load the new operating
system from disk into the
memory of one processor
(system load).
TSM Low-Level Link
Application or OSM Low-
Level Link
Section 11, Loading the
G06.24 RVU
14. Reload the new operating
system into the rest of the
processors.
TACL RELOAD
command
Section 11, Loading the
G06.24 RVU
15. Perform firmware updates
required after system load.
TSM Service Application
or OSM Service
Connection. (Must use
OSM for 6780 switch and
MSIO.)
Section 9, Updating SCSI
Boot Code (Pre-G06.08
RVU)
Section C, Updating SWAN
Concentrator CLIP
Firmware
16. Configure specific optional
products
SCF, macros Configure Specific Products
(Post-System Load) on
page 12-12
Table 1-6. Tasks and Tools for Installing the G06.24 RVU (page 2 of 2)
To Perform This Task... Use This Tool... Documented in...