Installation and Upgrade Guide

G06.24 Software Installation and Upgrade Guide—528593-005
5-1
5 Installing the G06.24 RVU
Installing a new RVU involves these DSM/SCM tasks:
1. Receive New Software Into the Archive
2. Create a New Software Revision
3. Build and Apply the New Software Revision
Alerts
Do not use this procedure to upgrade more than one NonStop S-series server at a time
or to install SPRs.
Before you install the G06.24 RVU, these requirements must be met:
•
Always install the latest D46 software product version (SPR) of DSM/SCM and the
DSM/SCM client before receiving the SUT. If you are using a pre-G06.20 RVU, use
RESTORE and activate the SWID (T9298D40^AAK) product. See Appendix B,
Installing the Latest DSM/SCM SPRs and Client Software before continuing.
•
If you are managing OSS files with DSM/SCM, check that the OSS Root Name
Server $ZPNS is started and running on the DSM/SCM Target. (See Create a New
Software Revision on page 5-8.) The volume where the SYSnn is being placed
must be activated as $SYSTEM to install the OSS files. See Appendix B in the
Open System Services Management and Operations Guide or if using EasySetup,
see Section 1 in the Open System Services Installation Guide.
•
Install the appropriate TSM or OSM server SPRs, and upgrade the system console
to the set of software delivered on the NonStop System Console Installer CD.
•
Check that SPRs have been installed for SQL/MX, DP2, if needed. See Table 3-3,
SPRs Required for NonStop SQL/MX Release 2.0 Fallback, on page 3-7
•
Check that other SPRs required for falling back from the G06.24 RVU have been
installed, including any SPRs for SQL/MX Release 2.0. (You cannot install SPRs
required for fallback after you have installed the G06.24 RVU.) A special OSS
SPR, T8622AAH, or later, ensures backward compatibility if you need to fall back
to an RVU prior to G06.12.
•
Save the configuration database.
•
Verify system operations. Review Section 4, Preparing to Upgrade the Server
Software.
Note. Until the T6031ABE, or later, SPR of DSM/SCM is installed, you should select the
Receive-all-files option on all inputs into the DSM/SCM Archive whether or not you want
to manage OSS files. When the T6031ABE, or later, SPR is applied, you can then choose
the Receive-all-files only if you want to manage OSS files.