HP Workstations - LSI 8888 8-port SAS RAID Controller Card Installation

Figure 10 Attaching the HDD-LED cable
Step 4—Reassembling the workstation
1. Reinstall the card support, if applicable.
2. Reinstall the side access panel.
3. Reconnect power to the workstation and all external devices.
4. Restore power to the workstation and all external devices.
Step 5—Loading and setting up driver software
For instructions on loading and setting up the SAS drivers for use with your workstation, see the
manufacturer’s documentation shipped with the 8-port SAS RAID controller.
At the time of component installation, look for device firmware and driver updates, designated for your
workstation model and operating system. You can obtain updates from
http://www.hp.com/go/
workstationsupport.
Step 6—Configuring RAID devices
NOTE: Verify the RAID card internal data connectors are enabled. For card setup instructions, see
the manufacturer's documentation included in this kit.
For detailed instruction on configuring RAID devices, see the service guide for the HP workstation model
at
http://www.hp.com/support/workstation_manuals.
Additional information is available at
http://www.hp.com/support/RAID_FAQs
12 LSI MegaRAID® SAS 8888ELP Host Bus Adapter installation ENWW