Intel vPro Processor Technology Setup and Configuration for the HP Z1, Z210, Z420, Z620 and Z820 Workstations

17
i. IPv6 Interface ID Type:
RANDOM ID (default) - The IPv6 Interface ID is automatically generated
using a random number as described in RFC 3041.
Intel ID - The IPv6 Interface ID is automatically generated using the
MAC address.
Manual ID - The IPv6 Interface ID is configured manually. Selecting this
type requires that the Manual Interface ID is set with a valid value.
ii. IPv6 Address. Enter a static IP address.
Default setting: (None)
Recommended setting: (Network depended)
Example: 2001:db8::1428:57ab
iii. IPv6 default Router. Enter the preferred DNS IPv6 address
Default setting: (None)
Recommended setting: (Network dependent)
Example: 2001:db8::1428:57ab
iv. Preferred DNS IPv6 Address. Enter the preferred DNS IPv6 address.
Default setting: (None)
Recommended setting: (Network dependent)
v. Alternate DNS IPv6 Address. Enter the alternate DNS IPv6 address.
Default setting: (None)
Recommended setting: (Network dependent)
Example: 2001:db8::1428:57ab
16. Activate Network Access. From the Intel ME Platform Configuration menu Figure
22), select Activate Network Access. This function causes the Intel ME to
transition to the POST provisioning state if all required settings are configured.
The Un-configure Network Access option will cause the Intel ME to transition to
PRE provisioning state.
Figure 22. Intel AMT Activate Network Access Screen
When MEBx displays “Update Network settings” in the General Settings menu
press Enter.