Intel vPro Processor Technology Setup and Configuration for the HP Z1, Z210, Z420, Z620 and Z820 Workstations

6
Manual Mode (SMB Mode) – AMT Setup and Configuration Procedure
When going through the options in the MEBx for the first time (Factory phase), the
default settings are in place. This whitepaper details HP recommended settings on
options, some of which may be the same as the default selection. Even though the
default setting is set and used for certain options, it is good practice to double
check important options.
1. Press Ctrl-P during POST to enter Management Engine BIOS Extension (MEBx)
Setup (Figure 1).
Figure 1. Intel MEBx Password Screen
2. Enter the default password of “admin” (passwords are case-sensitive). The user
must change the default password before any changes can be made in the
MEBx.
3. Change the password for the MEBx. The new password must meet the criteria
defined in the Password Guideline Section, also known as a strong password. It
must be entered twice for verification. Changing the password indicates that
AMT ownership has been established. The system will go from Factory phase to
In-Setup phase. The ME and AMT options within the MEBx are accessible and
the system can be accessed via the AMT WebGUI.