Owner manual

4. Use the arrow buttons to select Block faxes, and then press OK.
5. To block a fax number, use the arrow buttons to select Add entry, and then press OK. Enter the
fax number exactly as it appears in the header (including spaces), and then press OK. Enter a
name for the blocked number, and then press OK.
To unblock a single fax number, use the arrow buttons to select Delete entry, and then press
OK. Use the arrow buttons to select the fax number that you want to delete, and then press OK to
confirm the deletions.
-or-
To unblock all blocked fax numbers, use the arrow buttons to select Clear all, and then press
OK. Press OK again to confirm the deletions.
Make an extension telephone available to receive faxes
With this setting turned on, you can alert the product to pick up the incoming fax call by pressing 1-2-3
sequentially on the telephone keypad. The default setting is On. Turn this setting off only if you use
pulse dialing or if you have a service from your telephone company that also uses the 1-2-3 sequence.
The telephone company service does not work if it conflicts with the product.
1.
On the control panel, press Setup (
).
2. Use the arrow buttons to select Fax setup, and then press OK.
3. Use the arrow buttons to select Fax Recv. setup, and then press OK.
4. Use the arrow buttons to select Extension Phone, and then press OK.
5. Use the arrow buttons to select On or Off, and then press OK to save the selection.
ENWW Change fax settings 111