Software Instruction Manual

Toolkit utilities 56
Error code Error message Comment or clarification
2851 Invalid RAID Array ID.
The scripted RAID Array ID is invalid. Use characters from the
set a–z, A–Z, 0–9, !, @, #, *, (, ), ,, -, _, +, :, ., /, and
[space]. The ID cannot end with a space character or exceed
the maximum number of characters allowed by the controller.
2852 Invalid SSP state. —
2853
Cannot change SSP
settings.
—
2854 Invalid SSP adapter ID. —
2855
Controller does not support
logical drive SSP states. Use
the SSPState controller
command to set the
controller SSP state.
—
2856
Controller does not support
controller SSP state. Use the
LogicalDriveSSPState logical
drive command to set SSP
states for each logical drive.
—
2857 Invalid surface scan delay. —
2861
Controller does not support
redundancy settings.
The controller is not redundant or does not support
redundancy settings.
2864
Invalid preferred path
mode.
The specified value for the preferred path mode is not valid,
or the controller is not available.
2865 Invalid preferred path.
The specified preferred path is not a valid chassis slot for an
available active controller, or the controller is not available.
2866
Failure opening capture file
<text>.
—
2867
Failure opening input file
<text>.
—
2868
Failure opening error file
<text>.
—
2869 <text> command expected.
The <text> command is missing or in the wrong place in the
script file.
2870
<text> is not a supported
command.
—
2871
<text> is not a Controller
command.
The <text> command does not belong in the Controller
section of the script file.
2872
<text> is not an Array
command.
The <text> command does not belong in the Array section of
the script file.
2873
<text> is not a Logical Drive
command.
The <text> command does not belong in the Logical Drive
section of the script file.
2874
<text> is not an HBA
command.
The <text> command does not belong in the HBA section of
the script file.
2875
More than one <text>
command cannot exist in
the same section.
—