Software Instruction Manual

Toolkit utilities 60

Command-line argument Description

performing any additional actions.

-mouse

This argument causes HPONCFG to configure the server for optimized

mouse handling.

HPONCFG return codes

Value Meaning

The script was sent successfully to the device, or there is no RILOE II, iLO, iLO 2, or iLO

3 present in the system.

The script could not be sent to the device.

If the script itself fails, errors are reported in the log file created by HPONCFG.

HPONCFG command file contents

HPONCFG can be used to perform the following tasks:

• Obtain an entire configuration

• Obtain a specific configuration

• Set a configuration

Obtaining an entire configuration

HPONCFG can be used to obtain an entire configuration from an iLO, iLO 2, iLO 3, or a RILOE II. In this

case, the utility executes from the command line without specification of an input file. The name of the

output file is given on the command line. For example:

HPONCFG /w config.xml

In this example, the utility indicated that it obtained the data successfully and wrote it to the output file as

requested. The following is a typical example of the contents of the output file:

<MOD_DIR_CONFIG>

<DIR_AUTHENTICATION_ENABLED VALUE = "N"/>

<DIR_LOCAL_USER_ACCT VALUE = "Y"/>

<DIR_SERVER_ADDRESS VALUE = ""/>

<DIR_SERVER_PORT VALUE = "25"/>

<DIR_OBJECT_DN VALUE = " "/>

<DIR_OBJECT_PASSWORD VALUE = ""/>

<DIR_USER_CONTEXT_1 VALUE = ""/>

<DIR_USER_CONTEXT_2 VALUE = "_"/>

<DIR_USER_CONTEXT_3 VALUE = ""/>

</MOD_DIR_CONFIG>

<MOD_NETWORK_SETTINGS>

<SPEED_AUTOSELECT VALUE = "Y"/>

<NIC_SPEED VALUE = "100"/>

<FULL_DUPLEX VALUE = "Y"/>

<IP_ADDRESS VALUE = "16.100.241.229"/>

<SUBNET_MASK VALUE = "255.255.252.0"/>

<GATEWAY_IP_ADDRESS VALUE = "16.100.240.1"/>

<DNS_NAME VALUE = "ILOD234KJ44D002"/>