Operating Environment Software Owner's manual

• WARN—A configuration problem was found. The problem will not necessarily prevent correct operation,
but it may limit or restrict operation of some features.
• N/A—Not Applicable: the check does not apply to this type of system.
IOAssist execution timeout
The default timeout value for each IOAssist check is two minutes. A timeout indicates that the verified
component (Insight Orchestration, its subsystem or partner) either is not responding or is unavailable, or is
responding in an undesirable response time.
If IOAssist times out, you can only assume that the component is not responding in the expected response
time. You cannot assume that the component is unavailable. Any other conclusion is indicated by IOAssist
error messages.
Working with services
Service creation
Physical
Troubleshooting items addressed in this section:
• Unable to allocate servers and networks in the same Virtual Connect Domain Group. Either more
available servers are required, or could not match existing servers against memory size, disk space
and processor count requirements.
• Task for logical server <logical server name> …. Failure: At least one OS or software deployment has
failed. Check the deployment service to diagnose the details.
• Provisioning request for <service_id> has paused. Manual data disk allocation is required.
• Task for logical server <logical_server_id> has failed. Logical server job (ID = …) completed with a
failure status. The deployment server does not have the specified system UUID recorded. Deployment
Service Connector cannot confirm the system UUID provided by the caller.
• Task for logical server <logical_server_id> has failed. Job <job_id> has exceeded its timeout value of
<nnn> minutes. Marking the job as failed.
• Could not find server with serial number <serial_number>.
• The Manual Storage Provisioning email states that I should add more data LUNs than are required.
• I cannot add servers to an existing service using a Static IP address.
• A provisioning request remains paused during a manual storage allocation (approximately 5%), and
I cannot create a storage pool on HP Insight Dynamics because the VCDG is not listed on the Storage
Pools screen.
• The operating system deployment process through Insight Control server deployment fails when deploying
to a SAN booted physical server.
Unable to allocate servers and networks in the same Virtual Connect Domain Group.
Either more available servers are required, or could not match existing servers
against memory size, disk space and processor count requirements.
Failure message
Reservation failed because:Possible cause
• There were insufficient suitable servers in the server pools referenced in the Create Request.
• One or more servers considered available for use were actually in the maintenance pool.
• At least one of the server blades in a referenced user server pool already has a profile assigned.
62 Troubleshooting