Operating Environment Software Instruction Manual

5. To create a job folder for each required operating system, repeat this procedure.
6. To enable adding computers to the domain during provisioning, configure the Insight Control
server deployment domain authorization using Tools→Options→Domain Accounts.
Enclosures are discovered by Systems Insight Manager through the iLO IP address of the
enclosure. Be sure to use the iLO credentials of the Onboard Administrator enclosure as the
WBEM credentials.
7. In Matrix Operating Environment, create storage pool entries for automated SAN boot
provisioning. It's important to know the storage array port WWN/LUN (World Wide
Name/Logical Unit Number) when creating the entries. If these settings are unknown, modify
them after creating storage LUNs and zones. See “Manually creating SAN-backed storage
in Matrix OE visualization” (page 138).
8. Manually configure storage LUN presentation and zoning using the virtual HBA WWN in VC
profiles used when creating the storage pool entries. HP recommends creating a spreadsheet
to track storage mapping.
During provisioning, the server blade should see a SAN volume when booting. If it does not, check
the storage configuration settings.
Modifying the Erase ProLiant Hardware job
After installing Insight Control server deployment software, modify the default Erase ProLiant
Hardware job. To modify the job, do the following:
1. Save a copy of the default Erase job:
Configuring deployment servers 31