AB466A and AB467A Installation Guide

Installing the SCSI Miniport Driver

26 AB466A and AB467A PCI-X Host Bus Adapters for 64-Bit Windows Systems Installation Guide

Device Driver Installation

This section describes the instructions for installing the Windows SCSI Miniport

driver.

System Requirements

Ensure that your system meets these minimum requirements:

■ Installed HBA

■ StorageWorks Fibre Channel Storage subsystem (interconnect device and

storage device)

Installing or Upgrading a New Driver

The AB466A and AB467A HBAs are plug-and-play devices that are detected by

Windows operating systems. Perform the following steps to add or update the

Windows driver to a previously installed Windows system:

1. Install the HBA as described in Chapter 2 on page 17.

2. Restart or turn on the computer.

3. Browse to the the driver kit on the Smart Setup CD-ROM (or one you

downloaded from the website if it is more recent).

4. Double-click the Smart Component, cp00xxxx.exe.

Note: Refer to the following web site for the information about this Smart

Component’s version number:

http://h18000.www1.hp .com/storag e/saninf ra str uc ture.htm

5. Follow the installation wizard instructions.

6. When the installation completes, you must reboot.

7. Repeat step 1 through step 6 for any additional HBAs. Make sure to reboot

after installing the driver for the last HBA.