Smart Array P600 User Guide

8 HP Smart Array P600 Controller for Integrity Servers User Guide
If the server is using Linux®, controller installation is complete. When the server
is next rebooted, the operating system detects the controller hardware and
automatically loads the required driver.
If the server is using Microsoft® Windows®, continue as follows:
1. Load the controller driver from EBSU on the Smart Setup media. (To load
the driver, select Load OEM Boot Drivers at the appropriate point in
EBSU. For more information about Smart Setup, refer to the HP Smart Setup
Guide on the Smart Setup media.)
2. Run Express Setup.
3. When you have finished installing the operating system as directed during
the Express Setup procedure, remove the operating system CD and insert the
Smart Setup media.
4. Install the Integrity Support Pack ("Installing device drivers and
Management Agents" on page 19
).
Controller installation is complete.
The latest firmware, drivers, utilities, software, and documentation for HP
Integrity servers are available on the support page of the HP website
(http://www.hp.com/support/itaniumservers
).