User's Manual
Table Of Contents
- HP Moonshot Switch User and Maintenance Guide
- Abstract
- Notice
- Contents
- Component and LED identification
- Operations
- Setup
- Configuration
- Troubleshooting
- Illustrated parts catalog
- Removal and replacement procedures
- Regulatory information
- Electrostatic discharge
- Support and other resources
- Acronyms and abbreviations
- Documentation feedback
- Index
Setup 18
2.
Prepare the uplink module for installation.
3. Install the uplink module.
4. Do one of the following:
o If the switch module is already installed, verify the uplink module powers on and the health LED is
green.
o If the switch module is not installed, install the switch module before verifying LEDs.
For more information, see the "Installation information and guidelines (on page 16)."
5. After both components have been installed, verify the switch firmware is at the recommended firmware
version. For more information, see the HP website (http://www.hp.com/go/moonshot/download).
The installation is complete.
Installing the switch module
CAUTION: To avoid connectivity loss, do not remove switches already in operation.
To install the switch module:
1. Extend the chassis from the rack (on page 12).
2. Remove the access panel (on page 13).