User's Manual

Configuration 28
o
No flow control
3. Start the terminal.
The switch login prompt appears.
4. Enter: admin
No password is set by default.
Obtaining the switch management IP address
To access the switch console remotely, be sure network connectivity is established with the iLO CM
management port (on page 11).
If DHCP services are provided on the network, obtain the switch management IP address:
1. Access the switch CLI interface locally.
2. Enter privileged exec mode. At the switch prompt, enter:
enable
3. Show the switch management IP address. At the privileged exec prompt, enter:
show serviceport
If DHCP services are not available, configure the serviceport IP address.
Be sure to configure the enable password before managing the switch remotely.
To configure the switch, see the Switch Administrator's Guide and the Switch CLI Command Reference in the
HP Moonshot Information Library (http://www.hp.com/go/moonshot/docs).
Configure the Enable password
The Enable password controls access to the privileged exec mode. The default authentication profile denies
remote access to the privileged exec mode if the Enable password is not configured. Configure the Enable
password before starting a remote session.
To configure the password:
1. Access the CLI locally (on page 27).
2. To access the privileged exec mode, enter the following command:
enable
No password prompt appears if a password is not configured.
3. To configure the Enable password, enter the following command:
enable password {password}
Interacting with the switch from the iLO CM firmware
Use the following iLO CM firmware commands to show switch information, set switch parameters, or connect
to the switch console.
To show switch information:
o show switch info
o show switch list
o show switch sn {sa|sb|sa-b}
o show switch pid {sa|sb|sa-b}