User's Manual
Table Of Contents
- HP Moonshot Switch User and Maintenance Guide
- Abstract
- Notice
- Contents
- Component and LED identification
- Operations
- Setup
- Configuration
- Troubleshooting
- Illustrated parts catalog
- Removal and replacement procedures
- Regulatory information
- Electrostatic discharge
- Support and other resources
- Acronyms and abbreviations
- Documentation feedback
- Index
Configuration 29
o
show firmware revisions
o show switch power
o show switch temperature
To set switch power or switch UID LED:
o set switch power {off|on} {sa|sb|sa-b}
o set switch uid {off|on} {sa|sb|sa-b}
To connect to the switch console using the virtual serial port:
connect switch vsp {sa|sb}
If the virtual serial port is not configured, configure the virtual serial port before connecting to the switch
console:
1. Enable VSP:
set switch vsp on {sa|sb}
2. Reload the switch:
set switch power off {sa|sb}
Traffic is halted on the associated switch.
set switch power on {sa|sb}
For more information on interacting with the switch from the iLO CM firmware, see the HP Moonshot iLO
Chassis Management CLI User Guide in the HP Moonshot Information Library
(http://www.hp.com/go/moonshot/docs).