User's Manual
Table Of Contents
- HP Moonshot Switch User and Maintenance Guide
- Abstract
- Notice
- Contents
- Component and LED identification
- Operations
- Setup
- Configuration
- Troubleshooting
- Illustrated parts catalog
- Removal and replacement procedures
- Regulatory information
- Electrostatic discharge
- Support and other resources
- Acronyms and abbreviations
- Documentation feedback
- Index
Removal and replacement procedures 35
Removal and replacement procedures
Removing the switch module
CAUTION: Be sure to save the running-configuration of the switch before removing any switch
components.
CAUTION: To avoid connectivity loss, do not remove switches already in operation.
CAUTION: For proper cooling, be sure every switch module bay and uplink module bay has either
a blank or a module installed.
To remove the switch module:
1. Extend the chassis from the rack (on page 12).
2. Remove the access panel (on page 13).
3. Locate and remove the switch module.
Removing the uplink module
CAUTION: Be sure to save the running-configuration of the switch before removing any switch
components.
CAUTION: To avoid connectivity loss, do not remove switches already in operation.