User's Manual

5. Configure the following settings in the Advanced section:
• Ping gateway on startup—Causes the iLO CM Firmware to send four ICMP echo request
packets to the gateway when the Moonshot 1500 CM module initializes. This ensures
that the ARP cache entry is up-to-date on the router responsible for routing packets to and
from the Moonshot 1500 CM module.
• Use DHCPv4 for—Select from the following check boxes to configure the values that will
be provided by the DHCP server.
◦ Gateway—Specifies whether the DHCP server-supplied gateway is used. If DHCP is
not used, enter a gateway address in the Gateway box in the IPv4 section.
◦ Domain name—Specifies whether the DHCP server-supplied domain name is used.
If DHCP is not used, enter a domain name in the Domain Name box in the Host name
section.
◦ DNS—Specifies whether the DHCP server-supplied DNS server list is used. If not,
enter the DNS server addresses in the Primary DNS server, Secondary DNS server,
and Tertiary DNS server boxes in the DNS section.
◦ NTP—Specifies whether the DHCP server-supplied NTP service locations are used.
If not, enter the NTP servers on the Time Settings page.
Managing network settings 53