User's Manual

◦ WINS—Specifies whether the DHCP server-supplied WINS server list is used. If not,
enter the WINS server addresses in the Primary WINS server and Secondary WINS
server boxes in the WINS section.
◦ Static routes—Specifies whether the DHCP server-supplied static routes is used. If
not, enter the static route destination, mask, and gateway addresses in the Static
routes section.
6. If DHCPv4 is not used for the DNS settings, click DNS, and then configure the following settings
in the DNS section:
• Primary DNS server—If Use DNS servers is enabled, this value is supplied automatically.
If not, enter the primary DNS server address.
• Secondary DNS server—If Use DNS servers is enabled, this value is supplied automatically.
If not, enter the secondary DNS server address.
• Tertiary DNS server—If Use DNS servers is enabled, this value is supplied automatically.
If not, enter the tertiary DNS server address.
• DDNS registration—Select or clear this check box to specify whether the Moonshot 1500
CM module registers its IPv4 address and name with a DNS server.
7. If DHCPv4 is not used for the WINS settings, click WINS, and then configure the following
settings in the WINS section:
• Primary WINS server—If Use WINS servers is enabled, this value is supplied automatically.
If not, enter the Primary WINS Server address.
• Secondary WINS server—If Use WINS servers is enabled, this value is supplied
automatically. If not, enter the Secondary WINS Server address.
• WINS registration—Select or clear this check box to specify whether the Moonshot 1500
CM module registers its name with a WINS server.
8. If DHCPv4 is not used for the static route settings, click Static routes, and then configure the
following settings in the Static routes section:
• Static route #1—The static route 1 destination, mask, and gateway addresses. If Use static
routes is enabled, this value is supplied automatically. If not, enter the static route value.
• Static route #2—The static route 2 destination, mask, and gateway addresses. If Use static
routes is enabled, this value is supplied automatically. If not, enter the static route value.
• Static route #3—The static route 3 destination, mask, and gateway addresses. If Use static
routes is enabled, this value is supplied automatically. If not, enter the static route value.
9. Click Apply to save the changes.
A message similar to the following appears:
The chassis manager will automatically reset to apply the settings.
Continue to apply the settings and reset the chassis manager?
10. Click Yes.
A reset ends all active sessions. It might take several minutes before you can re-establish a
connection.
54 Configuring Moonshot System