User's Manual

4. Reinsert the Moonshot 1500 CM module and wait for it to boot.
5. Connect to the Moonshot iLO CM firmware using a serial port or SSH. When the Login prompt
displays, press Enter twice.
WARNING! While the security override is toggled, anyone may log into the chassis manager
as the Administrator because no password is required. Anyone accessing the Moonshot iLO
CM firmware will see a security alert display after login.
6. Set up a new account or reset the password for the Administrator account.
The following example shows how to find the list of existing user accounts and modify one to
have a known password “Moonsh0t”:
Example 1 Resetting the Administrator password
hpiLO-> show user all
Local User Accounts:
#-----------------------
Current User:
User Name: Administrator
Full Name: Administrator
User Privilege: ADMINISTRATOR
Status: ENABLED
hpiLO-> set user password Administrator Moonsh0t
User: "Administrator" password set.
To configure a new user, you may need some or all of the following commands:
• show user all
• set user password
• set user privilege
• enable user
• remove user
• set password minimum
7. After creating a new user account or resetting the Administrator password, remove the
Moonshot 1500 CM module.
The following changes occur while the Moonshot 1500 CM module is removed:
• Chassis fans automatically switch to maximum speed.
• Powered cartridges remain on, and cartridges without power remain off.
• Cartridge buttons (power, UID, Link) do not work.
Management capabilities resume and chassis fans switch to an appropriate speed after the
Moonshot 1500 CM module is reinserted.
8. Restore the security DIP switch to its original position.
Bypassing a lost or forgotten administrator password 69