iX 6.5)

Chapter 1 17

Introduction to Internet Services

Overview of Internet Services

System Requirements

The Internet Services program and conﬁguration ﬁles come with

version C.55.00 or greater, of the MPE/iX Fundamental Operating

Software (FOS). (The exception to this is the Telnet Client, which was

made available to customers on the earlier version of MPE/iX, C.50.00.)

As part of MPE/iX FOS, Internet Services can run on any Precision

Architecture-RISC model of the HP 3000. They are not available on

earlier “classic” HP 3000 computers running MPE V.

To run Internet Services, you must:

• Conﬁgure one or more network interface link cards that support

TCP/UDP/IP communications protocol.

• Conﬁgure the Net Transport communications software which uses

the TCP/UDP/IP protocol.

The necessary software and at least one TCP/UDP/IP network interface

card is delivered with each PA-RISC HP 3000 system. Internet Services

runs on top of the Net Transport software and therefore runs over any

type of link supported by Net Transport.

Verifying Installation of Internet Services Files

If you have installed or updated to version C.60.00 of MPE/iX, use the

following steps to verify that the Internet Services ﬁles exist on your

system:

1. If necessary, log on the system as MANAGER.SYS.

2. Enter a LISTFILE command for the NET group of the SYS account:

:LISTFILE @.NET.SYS

3. Check the list displayed on your screen and make sure that you have

the following ﬁles:

BOOTPD BOOTPQRY

BPTABSMP INETD

INSECSMP INSVXL

JINETD PROTSAMP

REMSH SERVSAMP

TFTPD

4. Run the Node Manager Maintenance utility to verify that you have

successfully installed the set of Internet Services ﬁles (except for

Telnet ﬁles, which you will check in Chapter 3 , “Telnet Service.”)

:NMMAINT,73