Dictionary/3000 Reference Manual (32244-90001)

Chapter 6 187

The Dictionary DICTPDE Utility

Changing Input, List and Output Files

The following is an example of how to run DICTPDE within a job stream. Note that in this

example, DICTPDE will accept commands from the command ﬁle COMMANDS and write

the generated declarations to the output ﬁle OUTPUT.

!JOB CODEGEN, LYNN.ACCTS

!FILE DICTIN = COMMANDS

!FILE DICTOUT = OUTPUT

!RUN DICTPDE.PUB.SYS

MGR

!EOJ

Note that the Dictionary password must be supplied in the job stream immediately after

the MPE RUN command for DICTPDE. In the above case, the password used is MGR.

Also, remember to create the command ﬁle COMMANDS with the EDITOR before

streaming this job. (Don't forget to include an EXIT command at the end of the command

ﬁle to terminate DICTPDE.)