Dictionary/3000 Reference Manual (32244-90001)

244 Chapter7
The Dictionary DICTCDE Utility
The DICTCDE Main Prompt
Prompt for record data item
prefixes (Y/N)> allows you to suppress the prompts for prefixes for data
items.
Prompt for all sections of MPE/KSAM
definitions (Y/N)> allows you to suppress the prompts for the
ENVIRONMENT DIVISION and FILE SECTION.
Prompt for VPLUS field types and
number tables (Y/N)> allows you to suppress the prompts for selecting the
VPLUS field types and the VPLUS field number tables.
DICTCDE will then issue the first option:
Dictionary name (current dictionary )>
Enter the Dictionary name, group and account to be opened and used for further code
generation. DICTCDE displays the current Dictionary being used in (current dictionary).
Data and file definitions are extracted from the new Dictionary specified until this option
is changed again. When a new Dictionary name is specified, DICTCDE will also issue the
following prompt:
Dictionary password>
Enter the Dictionary password for the new Dictionary to be used. If the new Dictionary
specified is the same as the previous Dictionary, the password prompt will not be issued. If
[[RETURN]] is pressed in response to this option, the Dictionary used will not change and
DICTCDE will continue to the next option as follows:
Copylib file name (current copylib )>
Enter the copylib file name (35 characters maximum) to be opened and used for further
code generation. DICTCDE displays the current copylib file being used in current copylib.
If the new copylib file already exists, DICTCDE will open that copylib file and append any
further source code generated to the contents of that file. If the specified copylib file name
exists, but it is not in KSAM copylib format, DICTCDE will issue an error message and
reprompt for the copylib file name. If the specified file name does not exist, DICTCDE will
issue the following prompt:
File filename does not exist, create it (N/Y)>
If N is entered in response to this prompt, DICTCDE will reprompt for the copylib file
name. If Y is entered in response to this prompt, DICTCDE will prompt for the key file
name for the new KSAM copylib to be created:
Key file name>
Enter the key file name for the new copylib file (8 characters maximum). If [[RETURN]] is
pressed in response to this prompt, DICTCDE will reprompt for the copylib file name.
Once a new copylib is accepted, or if [[RETURN]] is pressed in response to the copylib file
option prompt, DICTCDE would continue to the next option as follows:
Run COBEDIT (N/Y)>
Enter Y to run the copylib editor COBEDIT from within DICTCDE. DICTCDE will then
close the current copylib file being used and invoke COBEDIT for you. (For information on
running COBEDIT, see the COBOL II Reference Manual.) When you exit COBEDIT,