Dictionary/3000 Reference Manual (32244-90001)

Appendix B 299
UTILITY Error Messages
DICTDBA Messages
DICTDBA Messages
Errors
Warnings
MESSAGE EXPLANATION AND/OR ACTION
*ERROR: BASE NAME TOO LONG Data base name, including qualifiers, is greater than 24
characters.
*ERROR: DATA BASE OPERATION: A data base error occurred when reading information.
An IMAGE “DBEXPLAIN message block” is issued to
explain the error condition.
*ERROR: INVALID MODE Response to MODE prompt is a number other than 1
through 8.
*ERROR: INVALID RUN MODE An incorrect response to RUN MODE prompt entered.
*ERROR: LIST FILE OPERATION An error occurred during writing the list file
(DICTLIST).
*ERROR: PASSWORD LONGER THAN 8
CHARACTERS
Response to BASE PASSWORD prompt is greater than
8 characters.
*ERROR: LIST FILE OPEN Device LP is not available. Use a file equation to
redirect DICTLIST.
MESSAGE EXPLANATION AND/OR ACTION
*WARNING: BROKEN CHAIN(S): A broken chain has been encountered in a detail set. The
data base should be unloaded serially with DICTDBU
and then reloaded with DICTDBL to recover the data
base.
*WARNING: CONTROL(Y) NOT ENABLED Attempt to enable Control Y failed.
*WARNING: HIGH MASTER SET OCCUPANCY The occupancy of a master set is higher than 80%.
Consider increasing the data set capacity to reduce the
occurrence of synonym chains (unless the capacity is
only one entry).
*WARNING: SERIAL COUNT ERROR Physical serial read count of a master set does
not equal the IMAGE table count. The data base
should be unloaded serially with DICTDBU and
then reloaded with DICTDBL to recover the
data base.