MPE/iX Shell and Utilities Reference Manual, Vol 1

co(1) MPE/iX Shell and Utilities co(1)
DIAGNOSTICS
Possible exit status values are:
0 Successful completion.
1 An error occurred while checking out one of the specified files.
The RCS file name, the working file name, and the revision number retrieved are written to the
diagnostic output.
Messages
Message: –K has precedence over –k
Cause: You specified both the –K option and the –k option. These two options are
mutually exclusive. The command behaves as though only the –K option was
specified.
Action: If you do not want the behaviour described under CAUSE, specify only one of
the two options.
Message: –l has precedence over –u
Cause: You specified both the –l option and the –u option. These two options are
mutually exclusive. The command behaves as though only the –l option was
specified.
Action: If you do not want the behaviour described under CAUSE, specify only one of
the two options.
Message: –x has precedence over –k
Cause: You specified both the –x option and the –k option. These two options are
mutually exclusive. The command behaves as though only the –x option was
specified.
Action: If you do not want the behaviour described under CAUSE, specify only one of
the two options.
Message: Can’t adjust mode of filename: system error
Cause: See syserror(3).
Action: See syserror(3).
Message: cannot create "filename": system error
Cause: See syserror(3).
Action: See syserror(3).
Message: Can’t create workfile; see new_workfile: system error
Cause: See syserror(3).
Action: See syserror(3).
1-114 Commands and Utilities