MPE/iX Shell and Utilities Reference Manual, Vol 1

cpio(1) MPE/iX Shell and Utilities cpio(1)
DIAGNOSTICS
Possible exit status values are:
0 Successful completion.
1 An error occurred.
Messages
Message: –6 not supported
Cause: You specified the –6 option, which is not currently implemented.
Action: Do not use the –6 option.
Message: –I: Must specify –i option
Cause: You specified the –I option, but did not specify the –i option.
Action: To use the –I option, you must specify the –i option.
Message: –O: Must specify –o option
Cause: You specified the –O option, but did not specify the –o option.
Action: To use the –O option, you must specify the –o option.
Message: –r option disabled with –p
Cause: You specified the interactive renaming option (–r) with the pass option (–p).
cpio does not allow this combination.
Action: Do not specify the –r option on the same command line with the –p option.
Message: Directory "pathname": system error
Cause: See syserror(3).
Action: See syserror(3).
Message: I/O buffer allocation: system error
Cause: See syserror(3).
Action: See syserror(3).
Message: Insufficient memory: system error
Cause: See syserror(3).
Action: See syserror(3).
Message: Must specify one of –i, –o, or –p
Cause: You must specify one of the –i, –o,or–p options. You failed to do so.
Action: Specify one of the required options.
Message: Unknown option "–option"
Cause: You specified an option that is not valid for cpio.
Action: Check the DESCRIPTION section for a list of valid cpio options.
1-136 Commands and Utilities