Using NS3000/iX Network Services (36920-90008)

Chapter 5 71
Network File Transfer
DSCOPY
DSCOPY
Transfers or copies a disc file from one node to another (or within a
single node).
Syntax
[sourcefile [sfileloc] [to [targetfile] [tfileloc][;opt]]]
DSCOPY [+[sfileloc] [to [tfileloc][;opt]. . .]
[+opt[;opt]...
Use
Available In Session? Yes
In Job? Yes
In Break? No
Programmatically? No
Breakable? No
Capabilities? None
Parameters
sourcefile The name of the file to be transferred, optionally
including qualifiers.
Specify HP 3000 source files as follows:
filename[/lockword][.groupname.[accountname]]
The sourcefile may be a formal designator defined in a
prior file equation. If the sourcefile is a formal designator
defined in a prior file equation, then the sourcefile must
be preceded by an asterisk.
The sourcefile parameter may also specify a generic file
set, via MPE/iX “wildcard” characters “@”, “#”, or “?”.
See “Multiple Transfer” later in this chapter for more
information on generic file sets.
sfileloc A node specification for the source file, in the form:
[delim [location]] [[[logon]]]
where delim is either a colon (:) or a comma (,).
The location parameter is either a node name or a
previously defined environment ID. Logon must be a
valid logon sequence for the node in question, including
all necessary passwords. If specified, the logon is used
to create a temporary remote session on the node. Note
that brackets are required around the logon sequence.