ALLBASE/SQL Message Manual (36216-90213)

230 Chapter7
ALLBASE/SQL Error Messages: 2800-8220
entered incorrectly.
ACTION Use the SQLUtil HELP command or refer to the
ALLBASE/SQL Database Administration Guide to obtain
a list and description of valid SQLUtil commands.
8102 MESSAGE Command not yet implemented. (DBERR 8102)
CAUSE The command name you entered does not exist or was
entered incorrectly.
ACTION Use the SQLUtil HELP command or refer to the
ALLBASE/SQL Database Administration Guide to obtain
a list and description of valid SQLUtil commands.
8103 MESSAGE File '!' not found. (DBERR 8103)
CAUSE The file name specified in the MOVEFILE or PURGEFILE
command was entered incorrectly or does not exist.
ACTION Check your spelling. Use the MPE/iX LISTF command to
verify the existence of the specified file.
8111 MESSAGE Re-typed maintenance word doesn't match.
Maintenance word not changed. (DBERR 8111)
CAUSE The maintenance word was not changed because SQLUtil
was unsure what the new maintenance word should be.
ACTION Issue the SETDBEMAINT command.
8115 MESSAGE Value must be in the range !..!. (DBERR 8115)
CAUSE The value specified for one or more parameters of the
ALTDBE is invalid.
ACTION Issue the ALTDBE command again, specifying valid
numbers for following parameters: Number of Runtime
Control Block Pages should be 17 to 128 pages; Number of
Data Buffer Pages should be a minimum of 15; Number of
Log Buffer Pages should be 24 to 120 pages; and Max.
Transactions should be 2 to 240 transactions.
8116 MESSAGE Bad numeric input. (DBERR 8116)
CAUSE You entered non-numeric input where numeric input was
expected.
ACTION Issue the ALTDBE command again, specifying valid
numbers.
8118 MESSAGE Cannot open file. (! !). (DBERR 8118)
CAUSE An MPE/iX file system error occurred.
ACTION Refer to the
MPE/iX Error Message Manual, Volume
1
for an error description.
8131 MESSAGE File '!' is not a DBEFile. (DBERR 8131)