ALLBASE/SQL Message Manual (36216-90213)

278 Chapter9
ALLBASE/SQL Error Messages: 11007-22540
without first having done a SETUPRECOVERY.
ACTION Issue the SETUPRECOVERY command before the
RECOVERLOG or ENDRECOVERY commands.
13323 MESSAGE Log does not contain an archive checkpoint.
(DBERR 13323)
CAUSE An archive checkpoint was not written to the log file, so
the log file cannot be used for rollforward recovery.
ACTION Refer to the ALLBASE/SQL Database Administration
Guide for additional information on archive checkpoints,
and to the ALLBASE/SQL Reference Manual for
information on the BEGIN ARCHIVE and COMMIT
ARCHIVE statements.
13324 MESSAGE Archive mode was never enabled on this
DBEnvironment. (DBERR 13324)
CAUSE You attempted a SETUPRECOVERY on this
DBEnvironment, but archive mode was never turned on.
ACTION Check the sequence of operations. Perhaps this log is a
non-archival log, and has always been so. If that is the
case, do not attempt rollforward recovery on this log.
13325 MESSAGE Log mode specification should be SINGLE or
DUAL. (DBERR 13325)
CAUSE You entered an incorrect log mode in response to a prompt
from SETUPRECOVERY in SQLUtil.
ACTION Response with either SINGLE or DUAL.
13326 MESSAGE Specified log id is out of range. (DBERR
13326)
CAUSE The specified log id is either < 1 or > 35 when you issued
either the PURGELOG or STORELOG command.
ACTION Use the SHOWLOG command to get the appropriate log
id.
13331 MESSAGE SHOWLOG internal error in computing free log
blocks. (DBERR 13331)
CAUSE Internal corruption.
ACTION Record as much information as possible and contact your
HP Service Representative or Response Center.
13338 MESSAGE FORMAL Designator is Invalid. (DBERR 13338)
CAUSE The group and account do not match.
ACTION Supply the correct MPE/iX group and account name.
13339 MESSAGE SETUPRECOVERY has already been done (DBERR
13339)