ALLBASE/SQL Message Manual (36216-90213)

306 Chapter10
ALLBASE/SQL Error Messages: 22800-
have sufficient resources. (DBERR 30131)
30158 NetIPC Error: Connection request
rejected by remote. (DBERR 30158)
ACTION Refer to the NetIPC Error Codes in the HP 9000 NetIPC
Programmer's Guide.
31000 MESSAGE Datacommunication BSD failure. (DBERR 31000)
CAUSE A data communication error occurred.
ACTION Record as much information as possible and contact your
HP Service Representative or Response Center.
31004 MESSAGE The connect sequence was interrupted before
completion. (DBERR 31004)
CAUSE The connect sequence could not be completed.
ACTION Restart the application.
31009 MESSAGE Invalid virtual circuit descriptor. (DBERR
31009)
CAUSE An internal error occurred. The internal virtual circuit
descriptor is not the one from the successful connect call.
ACTION Record as much information as possible and contact your
HP Service Representative or Response Center.
31014 MESSAGE Invalid data pointer specified in ARPA
sockets call. (DBERR 31014)
CAUSE An internal error occurred.
ACTION Record as much information as possible and contact your
HP Service Representative or Response Center.
31022 MESSAGE Invalid parameter specified in ARPA sockets
call. (DBERR 31022)
CAUSE An internal error occurred.
ACTION Record as much information as possible and contact your
HP Service Representative or Response Center.
31023 MESSAGE The system's table of open files is full.
(DBERR 31023)
CAUSE The socket call cannot be accepted because the system's
table is full.
ACTION Try to connect again later.
31024 MESSAGE The peer-process descriptor table is full.
(DBERR 31024)
CAUSE The socket call cannot be accepted because the
application's open file exceeds the per-process limit.