ALLBASE/SQL Message Manual (36216-90213)

312 Chapter10
ALLBASE/SQL Error Messages: 22800-
attempt.
ACTION Correct the security parameters specified in the NETUtil
AliasDB file entry.
33003 MESSAGE LU 6.2 Send not allowed, partner LU has send.
(DBERR 33003)
CAUSE The HP side of the LU 6.2 connection has attempted a
send when a send is disallowed by the protocol.
ACTION This error should not occur. In the event that it does,
transmission errors may have occurred. Contact your HP
service representative or Response Center.
33004 MESSAGE LU 6.2 Communications connection error. ! ! .
(DBERR 33004)
CAUSE The APPC LU 6.2 routines have detected a
communications error.
ACTION Follow the action described for this code in the HP LU 6.2
API Reference manual. A brief summary of the error codes
may be obtained by issuing the command "print
catappc.pub.sys." Certain LU 6.2 codes may indicate
problems with the connection layers. For example
2
APPC does not have a NAU available for this connection
request. The APPCCONTROL SESSIONS can be used to
dynamically increase the number of sessions that APPC
attempts to start, but VTAM must be configured to allow
the increase.
19
APPC is not active
-9117
the connect between CICS and DB2 may not be active.
33121 MESSAGE Invalid function for foreign access. (DBERR
33121)
CAUSE The function is not available for foreign access. There are
two possible cases for this situation to occur: 1) An
attempt has been made to call a Switch routine that is not
valid for foreign access
or
2) FDA cannot identify the SQL function in the statement
being compiled.
ACTION If connected to a foreign DBE, use only those commands
that are valid for foreign access.