ALLBASE/SQL Message Manual (36216-90213)

316 Chapter10
ALLBASE/SQL Error Messages: 22800-
Service Representative or Response Center.
34077 MESSAGE Number of qualifying locks exceeds internal
maximum (max=!) (DBERR 34077)
CAUSE A limit has been reached.
ACTION Use the SET LOCKFILTER or SET LOCKTABFILTER
commands to reduce the number of locks that qualify. If
you need the limit increased, please contact your HP
Service Representative or Response Center.
34100 MESSAGE Input too long. Maximum length is !. (DBERR
34100)
CAUSE The total length of the input line exceeded the allowed
limit.
ACTION Issue the command again.
34102 MESSAGE Unexpected end of input. (DBERR 34102)
CAUSE An error was encountered trying to retrieve the next
command.
ACTION Check the output and input to see if all commands
executed properly.
34103 MESSAGE Illegal syntax. (DBERR 34103)
CAUSE Command was entered incorrectly.
ACTION Issue the command again. You can use the help facility to
verify your syntax.
34104 MESSAGE Illegal integer. (DBERR 34104)
CAUSE Numeric value was entered incorrectly.
ACTION Issue the command again.
34105 MESSAGE Integer value out of range. (min=!,max=!)
(DBERR 34105)
CAUSE The number specified was not between the min and max
values listed in the message.
ACTION Issue the command again.
34106 MESSAGE Illegal OWNER.TABLE value. (DBERR 34106)
CAUSE You did not specify a valid table name.
ACTION Issue the command again.
34107 MESSAGE Illegal PAGE/ROW ID value. (DBERR 34107)
CAUSE You did not specify a valid value.
ACTION Issue the command again.
34120 MESSAGE SystemFileName name is too long. Maximum