ALLBASE/SQL Message Manual (36216-90213)

Chapter 2 51
ALLBASE/SQL Warning Messages
catalog in use. (DBWARN 20010)
CAUSE The ALLBASE/SQL message catalog corresponding to
your language cannot be accessed, probably because it
does not exist.
ACTION Contact your system administrator.
20011 MESSAGE *** Bad JOB CONTROL WORD MIGLOGSZ. Default
size used. (DBWARN 20011)
CAUSE The job control word MIGLOGSZ has been set to an
integer value that is less than 400 (the default log size)
ACTION Issue the SETJCW MIGLOGSZ again, but specify a log file
size that is no less than 400.
20014 MESSAGE Cannot verify ALLBASE/SQL license. Assuming
IMAGE/SQL
(! !) (DBWARN 20014)
CAUSE An error occurred during processing that determines
whether or not your system is licensed to use
ALLBASE/SQL.
ACTION If you have not purchased a license to use ALLBASE/SQL,
no action is necessary. Otherwise, record as much
information as possible and contact your HP Service
Representative or Response Center, because restrictions
imposed by IMAGE/SQL are currently in effect for your
DBEnvironment.
20300 MESSAGE WARNING - No DBEnvironment has been
referenced yet. (DBWARN 20300).
CAUSE Either the CREATE DBEFILE or the ADD DBEFILE
statement was issued before a DBEnvironment had been
mentioned in a command.
ACTION Use either the SHOW 'DBEnvironmentName' VERSION
command or the PREVIEW command to indicate to
SQLMigrate which DBEnvironment should be used for
this command.
20550 MESSAGE WARNING - Before continuing, please verify
that a
complete backup of the DBEnvironment exists.
(DBWARN 20550)
CAUSE This warning is issued to insure that you do not
accidentally corrupt a DBEnvironment when using
SQLMigrate and you will be unable to recover your data.
If an unexpected error is encountered during the
MIGRATE or PREVIEW command, it is critical that a
backup of the DBEnvironment be available.