ALLBASE/SQL Message Manual (36216-90213)

Chapter 3 75
ALLBASE/SQL Error Messages: 1-745
14 MESSAGE '!' is not acceptable as a name for a stored
command. (DBERR 14)
CAUSE The name you specified for a command file did not conform
to operating system specifications. The command was not
stored.
ACTION Refer to the MPE/iX General User's Reference Manual for
file naming conventions.
15 MESSAGE '!' is not acceptable as a file name. (DBERR
15)
CAUSE The name you specified as a file name did not conform to
operating system specifications.
ACTION Refer to the MPE/iX General User's Reference Manual for
file naming conventions.
17 MESSAGE '!' cannot be found. (DBERR 17)
CAUSE The file name you specified does not exist or was entered
incorrectly.
ACTION Check your spelling. Use the MPE/iX LISTF command to
verify the existence of the specified file.
18 MESSAGE Error opening file '!'. (DBERR 18)
CAUSE The file you specified is currently being accessed.
ACTION Wait until a later time to access the file.
19 MESSAGE Valid options are F[ILE], S[ET], H[ISTORY],
I[NSTALL]. (DBERR 19)
CAUSE The option you specified in the LIST command is not a
valid option.
ACTION Issue the command again, specifying a valid option. Refer
to the ISQL Reference Manual for ALLBASE/SQL and
IMAGE/SQL for additional information on the LIST
command.
20 MESSAGE Valid options are F[ILE], C[URRENT],
H[ISTORY]. (DBERR 20)
CAUSE The option you entered for the RECALL command is not a
valid option.
ACTION Issue the command again, specifying a valid option. Refer
to the ISQL Reference Manual for ALLBASE/SQL and
IMAGE/SQL for additional information on the RECALL
command.
21 MESSAGE Cannot continue with INPUT command. (DBERR
21)
CAUSE Another error caused the INPUT command to be