ALLBASE/SQL Message Manual (36216-90213)

Chapter 3 77
ALLBASE/SQL Error Messages: 1-745
CAUSE The option value you specified for the AUTOCOMMIT,
CONTINUE, or ECHO option of the SET command was
not a valid option.
ACTION Issue the command again, specifying a valid option. Refer
to the ISQL Reference Manual for ALLBASE/SQL and
IMAGE/SQL for additional information on the SET
command.
33 MESSAGE Invalid command. (DBERR 33)
CAUSE The command you entered while viewing the results of a
SELECT statement was not valid.
ACTION Valid commands are u[p], d[own], l[eft], r[ight], t[op],
b[ottom], pr[int], e[nd], and p[ause].
34 MESSAGE FETCH is not allowed in ISQL. (DBERR 34)
CAUSE You issued a FETCH statement while in ISQL.
ACTION The FETCH statement can only be used in application
programs. Refer to the ALLBASE/SQL Reference Manual
for additional information.
35 MESSAGE Error reading from SelectFile. (DBERR 35)
CAUSE One or more users are accessing the same output file that
you specified in the OUTPUT option of the SET command.
ACTION Change the name of the output file using the OUTPUT
option of the SET command.
36 MESSAGE Problem executing such a long command. (DBERR
36)
CAUSE This is an internal error that occurs while executing an
SQL statement whose length is greater than 1.5
megabytes.
ACTION Record as much information as possible and contact your
HP Service Representative or Response Center. You can
work around this problem by shortening the length of your
command to less than 1.5 megabytes.
37 MESSAGE ISQL command too long. (DBERR 37)
CAUSE The number of characters in the ISQL command exceeded
the maximum limit of 2048 bytes.
ACTION Issue the command again, within the valid limits.
38 MESSAGE SYSTEM command unsuccessful. Return code is
!. (DBERR 38)
CAUSE The operating system command you issued from ISQL is
valid but cannot be executed.
ACTION Refer to the
MPE/iX Error Message Manual, Volume