ALLBASE/SQL Message Manual (36216-90213)

Chapter 3 81
ALLBASE/SQL Error Messages: 1-745
CAUSE Internal error.
ACTION Record as much information as possible and contact your
HP Service Representative or Response Center.
56 MESSAGE Output file name must be no more than !
bytes. (DBERR 56)
CAUSE The output file name you specified in the command is not a
valid system file name.
ACTION Refer to the
MPE/iX Error Message Manual, Volume
1
for additional information on file naming conventions.
57 MESSAGE Prompt must be no more than ! bytes. (DBERR
57)
CAUSE The prompt you specified in the PROMPT option of the
SET command exceeded the maximum length of 16 bytes.
ACTION Issue the command again, specifying a valid prompt
length.
58 MESSAGE Null character must be a single one-byte
character. (DBERR 58)
CAUSE You specified more than a single one-byte character as the
null indicator in the LOAD or UNLOAD EXTERNAL
command.
ACTION Issue the command again, specifying only a single
one-byte character as the null indicator.
60 MESSAGE Command file execution terminated. (DBERR 60)
CAUSE Execution was terminated because of an error in the
command file. An additional error message will be
returned.
ACTION Refer to the cause and action of the additional error
message.
61 MESSAGE Escape character must be a single one-byte
character. (DBERR 61)
CAUSE You specified more than a single one-byte character in the
ESCAPEoption of the SET command. The ESCAPE option
was not changed.
ACTION Issue the command again, specifying a single one-byte
character in the ESCAPE option.
62 MESSAGE SQLCORE not available. (DBERR 62)
CAUSE There is an ALLBASE/SQL linking problem.
ACTION Contact your system administrator.
63 MESSAGE Internal error: Unrecognized status code: !.
(DBERR 63)