ALLBASE/SQL Message Manual (36216-90213)

Chapter 3 85
ALLBASE/SQL Error Messages: 1-745
subcommands of the REDO command are invalid.
ACTION Issue the REDO command again. Refer to the ISQL
Reference Manual for ALLBASE/SQL and IMAGE/SQL
for additional information on the REDO command.
87 MESSAGE Must break line - too long. (DBERR 87)
CAUSE The bytes you added to the command using the insert
subcommand of the REDO command caused the line to be
greater than the maximum limit of 80 bytes.
ACTION Use the break subcommand before using the insert
subcommand again. Refer to the ISQL Reference Manual
for ALLBASE/SQL and IMAGE/SQL for additional
information on the REDO command.
88 MESSAGE No plus or minus sign. (DBERR 88)
CAUSE You used more than one + or - sign in the same line in the
REDO command.
ACTION If you want to go forward or backward more than one line,
use the +n or -n subcommand (where n is an integer).
Refer to the ISQL Reference Manual for ALLBASE/SQL
and IMAGE/SQL for additional information on the REDO
command.
89 MESSAGE No command to edit. (DBERR 89)
CAUSE You attempted to execute a REDO command when the
command history buffer was empty.
ACTION No action is necessary.
90 MESSAGE Redo not allowed in command buffer/command
file - ignored. (DBERR 90)
CAUSE You included a REDO command in either the command
buffer or command file.
ACTION Remove the REDO command and execute the command
buffer or command file again.
91 MESSAGE Problem opening installation file. (DBERR 91)
CAUSE Internal error.
ACTION Record the file system error code returned and as much
information as possible. Contact your HP Service
Representative or Response Center.
92 MESSAGE Problem reading from installation file. Code
= !. (DBERR 92)
CAUSE The installation file you specified did not contain a
module. No module was generated for the preprocessed
application.