ALLBASE/SQL Message Manual (36216-90213)

Chapter 3 99
ALLBASE/SQL Error Messages: 1-745
set.
ACTION Check which editor is currently set (through the SET
command). If the editor does not seem valid, change it
through the SET EDITOR command. Also check to make
sure it is possible to start the editor from outside
SQLAudit.
701 MESSAGE SQLGEN Error detected. SQLExplain messages
will follow. (DBERR 701)
CAUSE An unexpected ALLBASE/SQL error occurred.
ACTION Read the accompanying SQLExplain message to
determine the reason for the error and take corrective
action. If the error persists, contact your database
administrator.
702 MESSAGE Internal error. Missing message for SQLCODE
of !. (DBERR 702)
CAUSE The ALLBASE/SQL message catalog does not contain the
message associated with error encountered.
ACTION Contact your database administrator.
703 MESSAGE Could not CONNECT to DBEnvironment. (DBERR
703)
CAUSE SQLGEN could not connect to the DBEnvironment,
possibly because the name was not entered correctly or the
AUTOSTART option is OFF.
ACTION Correct conditions that may have caused the error. If the
error persist contact your database administrator.
704 MESSAGE Error occurred while RELEASING DBEnvironment.
(DBERR 704)
CAUSE An ALLBASE/SQL error occurred while releasing the
DBEnvironment.
ACTION Contact your database administrator.
706 MESSAGE Invalid Table Type encountered. RType = !.
(DBERR 706)
CAUSE Encountered an invalid RType in SYSTEM.TABLE.
ACTION Contact your database administrator.
707 MESSAGE Invalid DBEFile Type encountered. Type = !.
(DBERR 707)
CAUSE Encountered an invalid DBEFile in SYSTEM.DBEFILE.
ACTION Contact your database administrator.
708 MESSAGE Invalid Command Number encountered. Location
= !. (DBERR 708)