HP RPG/XL Programmer's Guide (30318-90001)

4- 52
Figure 4-25. Using the SIGEDITOR Forms Specification Screen
The lower part of the SIGEDITOR Forms Specification screen lets you
enable one or more of the function keys ( F2 - F7 ). To enable a
function key, enter an asterisk for it on this screen.
The function keys F3 - F8 let you simulate the function keys of the
same name on IBM 3x systems. To use them in an RPG program, you must
enable them in on this screen. The function keys are:
Function Key Description
PRNT (PRINT SCREEN) ( F2 ) When enabled, the function key label PRINT SCREEN
appears and lets you simulate the print screen key on
IBM3X systems. When not enabled, the label *PRINT
SCREEN appears at run time and the screen contents are
written to RSIPRINT (DEV=LP).
ROLL UP ( F3 ) Lets you simulate the ROLL UP key on IBM 3x systems.
ROLL DOWN ( F4 ) Lets you simulate the ROLL DOWN key on IBM 3x systems.
CLEAR ( F5 ) Lets you simulate the CLEAR key on IBM 3x systems.
HELP ( F6 ) When enabled, the function key label HELP appears and
lets you simulate the HELP key on IBM 3x systems. When
not enabled, the label *HELP appears and the application
hep facility is activated when the key is pressed.
REC BKSPC (RECORD BACKSPACE) ( Lets you simulate the REC BKSPC key on IBM 3x systems.
F7 )
The last part of the SIGEDITOR Forms Specification screen lets you enable
one or more command keys. You must enable the command keys before using
the corresponding command key indicators in an RPG program. Figure 4-25
shows that all of the command keys are disabled except for command keys
1, 2, 3, 5 and 8 (which correspond to command key indicators KA, KB, KC,