HP System Dictionary/XL Utilities Reference Manual - Part 1 SDDBD (32256-90003)

122 AppendixA
SDDBD Error Messages
SDDBD ERROR MESSAGES (2601–2821)
2773 MESSAGE: Command line out of range. Ignored (SDERR 2773)
CAUSE: The +/- REDO subcommand issued results in a line outside of the bounds of the
currently edited command.
ACTION: Make sure that the number specified with the +/- subcommand is within the
bounds of the edited command.
2774 MESSAGE: Illegal command after delete. Ignored (SDERR 2774)
CAUSE: Only the I subcommand is allowed after the D subcommand. You issued a series of
D’s followed by a character other than I.
ACTION: Issue the subcommand in a correct format.
2775 MESSAGE: String to insert too long to fit (SDERR 2775)
CAUSE: The I subcommand is issued with a string which is too long to fit into the line being
edited.
ACTION: Break the line with the B subcommand, and then add the string.
2776 MESSAGE: Redo sub-command is followed by unallowed characters
(SDERR 2776)
CAUSE: The REDO subcommand that does not take any argument is followed by other
characters.
ACTION: Make sure that you did not mean to replace corresponding part of the command
line with the string.
2777 MESSAGE: Move forward/backward issued with a non-integral argument
(SDERR 2777)
CAUSE: The +/- REDO subcommand is issued with a non-numeric argument.
ACTION: If you really meant to issue the +/- subcommand, reissue the subcommand with a
correct number following it.
2790 MESSAGE: No help on subject !. Displaying general help instead (SDERR 2790)
CAUSE: One of the subject names specified with the HELP command is not an SDDBD
command key word.
ACTION: Check the subject name pointed by ^, and see if it is misspelled
2791 MESSAGE: MPE command execution error (SDERR 2791). Error code: !“
CAUSE: An MPE command is issued with an illegal argument.
ACTION: Check the command argument, and see if it is correct.
2792 MESSAGE: No such MPE command (SDERR 2792). Error code: !“
CAUSE: An unknown MPE command is issued.
ACTION: Make sure that the command issued can be executed through the command
intrinsic.
2796 MESSAGE: Error occurred while forming the upshift table (SDERR 2796)
CAUSE: NLInfo NL intrinsic invocation failed.