HP System Dictionary/XL Utilities Reference Manual - Part 1 SDDBD (32256-90003)

Appendix C 137
SDDBC Error Messages
Driver/Validator Messages (4100–4124)
Driver/Validator Messages (4100–4124)
4100 0MESSAGE: Exceeded maximum number of allowed errors (SDWARN 4100)
CAUSE: The program encountered the number of errors specified as the maximum in the
PARM option.
ACTION: Correct the error(s) found and either rerun or finish running the job.
4101 0MESSAGE: Logging has been disabled (SDWARN 4101)
CAUSE: Logging has been disabled because the user does not want the program to
overwrite an existing log file.
ACTION: Do nothing and no logging will take place or exit the program and specify a new
file or a file that can be overwritten as the log file.
CAUSE: Logging has been disabled because the current log file has filled up and an
alternate log file was not available.
ACTION: Do nothing and no logging will take place or exit the program and specify a new
file or a file that can be overwritten as the log file.
CAUSE: Logging has been disabled because unable to write to the log file.
ACTION: Do nothing and no logging will take place or exit the program, refer to the
associated file error and correct the indicated problem.
4102 0MESSAGE: Logging proceeding onto a temporary log file (SDWARN 4102)
CAUSE: The permanent log file is full. Logging has been redirected to a temporary log file
with the same name as the permanent log file.
ACTION: No action is needed.
4103 0MESSAGE: SDLOG is a temporary file. Save if needed (SDWARN 4103)
CAUSE: The log file was saved as a temporary file.
ACTION: If the log file is not needed, do nothing and it will remain a temporary file. If the
log file is needed, save it.
4104 0MESSAGE: Expected End-Of-File NOT found in input file (SDERR 4104)
CAUSE: Unexpected input lines found in the input file after an EXIT command.
ACTION: Edit the input lines to remove the extra lines.
4105 0MESSAGE: Hit End-Of-File of input file before executed an EXIT (SDERR 4105)
CAUSE: Hit the end of the input file without finding an EXIT command.
ACTION: Edit the input file to place an EXIT command at the end.
4106 0MESSAGE: Invalid command (SDERR 4106)
CAUSE: The command entered is not recognized by the program.
ACTION: Issue a command that is recognized by the program. Use HELP for a list of valid
commands.