HP System Dictionary/XL Utilities Reference Manual - Part 1 SDDBD (32256-90003)

Appendix C 143
SDDBC Error Messages
Define Messages (4200–4209)
Define Messages (4200–4209)
4200 0MESSAGE: Both VERSION and STATUS were specified. STATUS is ignored
(SDWARN 4200)
CAUSE: Both the VERSION and STATUS keywords cannot be specified in the same
command. Either VERSION for a specific version, or STATUS for the last version of the
given status, should be used.
ACTION: Do nothing and the version will be used and the status ignored. The next time the
dictionary is opened, specify either the specific version (VERSION) or a specific status
(STATUS), but not both.
4201 0MESSAGE: Quoted passwords cannot extend to multiple lines (SDERR 4201)
CAUSE: If the password is entered with quotes, it must be entered on a single line.
ACTION: Specify the password so the opening and closing quotes are on the same line.
4202 0MESSAGE: Invalid scope password. Remember case counts (SDWARN 4202)
CAUSE: An invalid password has been entered in response to the scope password.
Remember that System Dictionary distinguishes between uppercase and lowercase
characters in a scope password.
ACTION: Specify the correct password for the scope.
4203 0MESSAGE: Exceeded maximum tries for a valid scope password (SDERR 4203)
CAUSE: Unable to open the dictionary because the valid scope password was not specified
within 3 tries.
ACTION: Reenter the Define command and specify the correct password for the scope.
4204 0MESSAGE: Unexpected End-Of-File on $STDINX (SDERR 4204)
CAUSE: Hit the end of the file on $STDINX when trying to read the scope password.
ACTION: Contact the DA. Internal Error.
4205 0MESSAGE: Unable to turn the echo facility off (SDERR 4205)
CAUSE: Unable to turn the echo facility off through the FControl Intrinsic when prompting
for the scope password
ACTION: Contact the DA (remember to get the associated file error). Internal Error.
4206 0MESSAGE: Unable to turn the echo facility on (SDERR 4206)
CAUSE: Unable to turn the echo facility on through the FControl Intrinsic after prompting
for the scope password.
ACTION: Contact the DA (remember to get the associated file error). Internal Error.