HP System Dictionary/XL Utilities Reference Manual - Part 1 SDDBD (32256-90003)

Appendix E 181
SDVPD Error Messages
SDVPD ERROR MESSAGES (3100–3458)
3210 MESSAGE: Could not close the forms file (SDERR 3210)
CAUSE: Vcloseformf intrinsic invocation failed.
ACTION: Notify the Dictionary Administrator or the System Manager of this problem.
3211 MESSAGE: Could not open the forms file (SDERR 3211)
CAUSE: Vopenformf intrinsic invocation failed.
Some other user is accessing the file exclusively.
ACTION: Check the file equate, if any, and see if the forms file actually exists.
CAUSE: The specified forms file does not exist.
ACTION: Request other users to reopened the forms file with shared access mode or wait
till they are finished.
CAUSE: Some other more grave system error.
ACTION:Act according to the additional error messages issued. If a serious problem is
suspected, notify the Dictionary Administrator or the System Manager.
3212 MESSAGE: No forms file open (SDERR 3212)
CAUSE: An attempt was made to access the forms file with none opened.
ACTION: Issue the VPLUS command to open the forms file and reissue the command that
caused this error.
3220 MESSAGE: Error while opening old SDLOG. Logging disabled (SDERR 3220)
CAUSE: 1. The old SDLOG is being accessed by some other user exclusively.
2. Some other error.
ACTION: Since logging is disabled, and SDLOG is not opened at all, you are not required to
take any action. However, if the command logging is essential for you, exit the program
immediately, take care of the problem, and reenter SDVPD. If a system error is suspected,
notify the System Manager.
3221 MESSAGE: Error while creating new SDLOG. Logging disabled (SDERR 3221)
CAUSE: Insufficient disc space.
ACTION: Build a small file and equate SDLOG to it. Notify the System Manager of the
insufficient disc space.
CAUSE: Some other error.
ACTION: Since logging is disabled, and SDLOG is not opened at all, you are not required to
take any action. However, if the command logging is essential, exit the program, take care
of the problem, and reenter SDVPD. Further, following actions are suggested:
Use a file equate to equate SDLOG to some other file and try. If a system error is
suspected, notify the Dictionary Administrator or the System Manager.
3222 MESSAGE: Error while opening old SDOUT. Report defaulting to $STDLIST
(SDERR 3222)
CAUSE: Old SDOUT could not be opened. The SDOUT report information will be output to
$STDLIST upon termination of the program.