HP System Dictionary/XL Utilities Reference Manual - Part 1 SDDBD (32256-90003)

Appendix E 185
SDVPD Error Messages
SDVPD ERROR MESSAGES (3100–3458)
3261 MESSAGE: REDO is not allowed in non-interactive mode (SDERR 3261)
CAUSE: REDO is issued in a non-interactive program environment. Remember that REDO
is not allowed in a non-interactive environment.
ACTION: Do not issue REDO in a non-interactive environment.
3262 MESSAGE: Illegal use of REDO (SDERR 3262)
CAUSE: The REDO command is issued to edit the command into another REDO.
ACTION: Do not edit your command into “REDO” through REDO.
3263 MESSAGE: Command line out of range. Ignored (SDERR 3263)
CAUSE: The +/- REDO subcommand issued results in a line outside of the bounds of the
currently edited command.
ACTION: Make sure that the number specified with the +/- subcommand is within the
bounds of the edited command.
3264 MESSAGE: Illegal command after delete. Ignored (SDERR 3264)
CAUSE: Only the “I” subcommand is allowed after the “D” subcommand. You issued a
series of D’s followed by a character other than “I”.
ACTION: Issue the subcommand in a correct format.
3265 MESSAGE: String to insert too long to fit (SDERR 3265)
CAUSE: The “I” subcommand is issued with a string which is too long to fit into the line
being edited.
ACTION: Break the line with the “B” subcommand, and then add the string.
3266 MESSAGE: String to append too long to fit (SDERR 3266)
CAUSE: The “A” subcommand is issued with a string which is too long to fit into the line
being edited.
ACTION: Break the line with the “B” subcommand, and then add the string.
3267 MESSAGE: REDO subcommand is followed by unallowed characters
(SDERR 3267)
CAUSE: The REDO subcommands that does not take any argument is followed by other
characters.
ACTION: Make sure that you did not mean to replace corresponding part of the command
line with the string.
3268 MESSAGE: Move forward/backward command can only have a number following it
(SDERR 3268)
CAUSE: The +/- REDO subcommand is issued with a non-numeric argument.
ACTION: If you really meant to issue the +/- subcommand, reissue the subcommand with a
correct number following it.
3270 MESSAGE: No help on subject !. Displaying general help instead (SDERR 3270)
CAUSE: One of the subject names specified with the HELP command is not an SDVPD