Read Before Installing MPE/iX Release 6.5 PowerPatch 5 (C.65.05) (30216-90358)

Information to Read before Installing MPE/iX 6.5 PowerPatch 5
NMCGDV0A job (IHFGDV0A) fails during Update from 6.0 to 6.5
Chapter 1
8
:run hpinstal
The installation process will detect where it left off, and will resume from that point.
NMCGDV0A job (IHFGDV0A) fails during Update from 6.0 to 6.5
When doing an Update from 6.0 to 6.5 using AUTOINST; option 3 (i.e. FOS, SUBSYS plus PowerPatch), an
installation job fails due to the inability to extract data from the NMCONFIG.PUB.SYS file. During Phase II of
AUTOINST, the installer will abort with the following message:
An installation job stream has failed. Job streaming: IHFGDV0A.INSTALL.SYS (INSTERR #23)
This condition can be resolved, and the installation can be resumed, by following these steps:
1. Convert the NMCONFIG file. From MANAGER.SYS, enter:
:NMMGRVER
When asked for the “Fileset to be scanned?” enter:
NMCONFIG.PUB.SYS
Reply ‘YES’ to convert the file.
2. Resume the installation. Simply run the installer program again.
:Run AUTOINST
You will be notified that an interrupted installation has been detected.
“Do you want to resume?”
Reply ‘YES’ to resume.