NS3000/iX NMMGR Screens Reference Manual - Edition 8 (36922-90038)

Chapter 7 145
X.25 Network Interface Configuration Screens
X.25 SVC Address Key Paths
X.25 SVC Address Key Paths
The X.25 SVC Address Key Paths screen (#162) in Figure 7-8 is
displayed when you press the
[Go To SVCPATH] function key at the General
X.25 Configuration screen (Figure 7-5). It is also displayed when you
type the path name:
@NETXPORT.NI.
NIname .PROTOCOL.X25.SVCPATH
in the Command window of any screen and press the
[Enter] key, where
NIname is a configured X.25 NI.
Figure 7-8 X.25 SVC Address Key Paths
The X.25 address key is a label which associates an X.25 address with
an IP address from the network directory. This provides you the
address of the remote host and the values of the connection parameters
you selected to use when communicating with that host. Every remote
address defined in the path table must be assigned a default facilities
set. You may configure up to 2048 SVC address keys under an
X.25 NI, and if configuring multiple X.25 NI’s, no address key
can be used more than once per system.
The default facilities set must be one of the defined facility sets in the
X.25 User Facility Set screen
(NETXPORT.NI.
NIname .PROTOCOL.X25.FACSET).